Write About Everything

Introduction:

JIC Fitting is a selection of hydraulic fittings which is produced in accordance to the SAE J514 requirements. The acronym JIC stands for Joint Industry Council. It’s also known as the JIC thirty seven degrees flare fitting because it’s a thirty seven degrees flare seating surface. These fittings are used on oil hydraulic systems in fields that are a lot of (fuel delivery, etc…), mobile hydraulic equipment, shipbuilding, fuel power application. A JIC fitting device has three components that create a tubing assembly: fitting, flare nut, and sleeve.

Material:

Materials used to fabricate JIC fittings include stainless steel and carbon steel SS316L.

Sizes:

JIC frame and ice hack weight loss reviews (this page) flare nut are obtainable in exterior diameter (“OD) sizes between 1/8″ to one 2”. Sleeve has two specific reading measurements, metric size (mm) and inch outer diameter (“OD). Sleeve size can be purchased from 3mm to 50mm as well as 1/8″ to 2”. Connecting sizes are designated by the corresponding outside diameter of the tubing for the numerous kinds of tube ends.

Working Pressure:

The standard functioning pressure of the fittings ranges from 1000 to 5000 psi for various sizes and connections. The minimum burst pressure is four times the working pressure. The JIC fittings must be able to withstand twice the working pressure for a period of one minute without failure or leakage.

Remember to take note that the pressure rating of an exact same fitting could vary when it is connected to various equipments.. For example, if a fitting with a minimal performing pressure is attached to a pipe, it is going to result in a general even reduce functioning strain. In all cases, always consider the lowest pressure as the maximum working pressure of the product.

So how does a JIC fitting works: For tube connections, the assembly treatment begins from the preparation of the hose. First, the nut as well as sleeve are inserted onto the conclusion of a hose. With all the usage of a flaring tool, form the conclusion of the tube to 37 degrees. Next, tighten the nut by making use of a spanner till the nut is tight and also the sleeve grips onto the tube. If the fittings are bench assembled, the gripping action can be motivated by rotating the hose manually as the nut is pulled down. When the tubing can easily not be rotated by hand, the sleeve has gripped onto the tube. If this occurs,, tighten the nut by switching it one complete turn. This may vary more or less with various tubing substances, but for general practice, it is a great rule to adhere to.

Configurations of JIC Fitting: Commonly utilized connection types be made up of: JIC/BSPP Male Connector, JIC/ NPT Male connector, JIC union, JIC/NPT Swivel Male Connector, JIC/BSPP Swivel Male Connector.

Brand of JIC Fittings:

HS Corporation is a Korean supplier specializing in JIC Fitting. Started in 1980, HS Corporation has over 30 years of specialised expertise in producing fittings.