Write About Everything

Peugeot 208 Key Replacement

Peugeot 208 key replacement should be left to experienced auto locksmiths who have the right tools and know-how. They can create and program keys quicker and more efficiently than dealerships.

A dead battery for your coin is most likely to be at fault the reason why your key fob isn’t locking or unlocking doors. However, there are many other reasons that the key may be malfunctioning.

Dead Coin Battery

A dead coin battery can hinder your Peugeot 208 from locking or unlocking, and will not allow you to start the engine. In this case you’ll need to employ the alternate method of starting as described in your vehicle’s owner’s manual.

Another reason your 208 might not start is that the spark plugs are been damaged. The spark plugs are responsible to ignite the fuel that powers the engine. However, they have a limited time of life. They’ll eventually fail in the event that they aren’t utilized enough.

There is a simple solution for this problem. Examine the voltage of your battery with a multimeter. If it’s lower than 11.5 Volts, then you need to replace it. It is also important to clean the contacts of the battery in the event that it is damaged by corrosion. You can do this by lifting the rubber covers covering the two terminals of the battery and using wire brushes to clean any corroded components of the battery. It is then time to reconnect the cables for the positive and negative poles.

Water Damage

If your 208 won’t start and the battery has not fallen flat, it is time to look at the spark plugs. It could be that they’re dirty, causing them not to spark. The spark plugs can be cleaned in a workshop.

Peugeot cars are equipped with a transponder key that works with the car’s ignition system. This ensures that only a valid key can turn the engine. If the chip inside the Peugeot key is damaged, then it won’t transmit the proper signal to the vehicle.

This is a very common issue that can occur due to water damage. This is a typical issue in more cold climates where the car is exposed to rain or snow. If this is the case, you should contact a reputable auto locksmith who has all the equipment and tools needed to modify the new key. They will also have the most up-to-date technology and equipment needed to make a Peugeot 208 smart key. The process shouldn’t be more than 15 minutes.

Faulty Battery Contacts

Peugeot replaced the old transponder chips with a brand new model that is based on electronic components mounted on a circuitboard. This new technology works great when it’s new, but over time the circuit boards begin to degrade and stop working properly.

This could stop the immobiliser chip from working, so your car won’t start. Contact an Peugeot specialist, or a locksmith if this is the case.

Another common issue is when the battery in the key fob starts to die, this causes the blade of the key to stop from entering the lock. A locksmith in your car can replace the battery and cut a new blade for you, this is generally a quick fix.

Faulty Receiver Module

It could be that the receiver module has a problem in the event that your Peugeot key fob fails to function after being dropped on the floor, or exposed to a sudden rainstorm or accidentally washed. The receiver module is responsible for transmitting radio signals to the onboard computer which controls the central locking system of your Peugeot vehicle.

The key fob itself is fitted with rubber seals that block water from getting to the chip inside. However, prolonged exposure to water could penetrate these seals and damage the chip. The high salt content of the pool or ocean waters could cause damage to the key fob, especially if it is submerged.

If your Peugeot spare key fob isn’t working You’ll need the module replaced. This can only by done by a Peugeot specialist or a professional auto locksmith. Unlike other cars, Peugeot keys are protected by an exclusive immobilizer system that requires the correct coding to start the engine. This is why you must be able to trust a professional peugeot key fob replacement locksmith with the task of designing and programming a replacement.

Computer malfunctioning on-board

The on-board computer in your Peugeot is responsible for a variety of the systems within your car, ranging from power windows to the airbags. When something goes wrong in these systems, it will typically show a code that identifies the issue. The code is stored in the system until the issue is resolved. Often, this will involve replacing the computer on board.

One of the most common reasons for peugeot Keys the airbag light coming on is loose or corroded connectors in the airbag sensor. This could be due to wear and tear, age or exposure to salt and moisture. This problem should be dealt with as soon as you can, as an airbag that is not functioning could pose danger in the event of an accident.

If your Peugeot is showing a card detected as not present error, the battery in the key fob may be weak or dead. This could prevent the key fob from sending a signal that disarms your vehicle’s standard immobilizer. You can test this by pressing the unlock button on the key fob and then trying to start your car. If this fails it is likely that the battery will need replacing.